If a place a Voltage Generator on a new schematic and then attempt to change the signal type (from the default Unit step) to any other type (e.g. sine wave) then Tina TI freezes and is unresponsive.

C2000ware 5.02 地址变量为：COM_TI_C2000WARE_INSTALL_DIR，CCS12.2以上版本能够直接匹配识别！ 但是C2000ware4.03版本地址变量为：COM_TI ...

Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?

When I read the values in the Registers Table in BQStudio for my battery assembly I see a voltage value of 7656 mV and individual cell voltage of 3830 mV (Cell 1), 3827 mV (Cell 2) and 3834 mV (Cell 3 ...

Hi! I am working with INA333 to amplify a wheatstone bridge output voltage. Here is the circuit in KiCAD: I am testing the circuit with the INA output connected to a stm32f405-microcontroller ADC pin.

I'm developing support for custom flash device "MX25L12833FM2I-10G". I'm having troubles using the flash in 1S-1S-4S. I managed to configure correctly the flash in the 1S-1S-4S protocol. After ...

Please try the steps below to debug this exception . 1. Keep break point in the Master's ISR 2. Note down the R14 Register 3. Search for the R14 register address in the Map file. Here, the address ...

I am using the TLV5636 12-bit DAC. I have noticed by single stepping through the debugger that the first DAC register write immediately following a Reference Select control register write is IGNORED.

TCAN4550 nINT中断到M3连接如上图所示。 M3想尽快收到CAN总线上的报文，以减少TCAN4550转换带来的通信延迟。 1、这里想通过nINT中断方式通知M3，当有外部中断来的时候，在M3的外部中断中进行接收 ...

I am using TPS546D24A in my design & below are the details. 1. I would like to calculate the power dissipation of this device. Is there any tool/excel available to calculate the Power dissipation of ...

Texas Instruments (TI) Logic support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search logic IC content or ask ...

I am using CCS version 11 and I would like to use SVN. I tried installing Subversive 4.0.5 from the Eclipse Marketplace, but the SVN Connector did not install properly and it didn't work. I also tried ...