If a place a Voltage Generator on a new schematic and then attempt to change the signal type (from the default Unit step) to any other type (e.g. sine wave) then Tina TI freezes and is unresponsive.

Even if I run PSpice-For-TI_setup.exe and enter my email address and access key, a message like the one attached appears and I cannot sign in. What could be the cause?

When I read the values in the Registers Table in BQStudio for my battery assembly I see a voltage value of 7656 mV and individual cell voltage of 3830 mV (Cell 1), 3827 mV (Cell 2) and 3834 mV (Cell 3 ...

Please try the steps below to debug this exception . 1. Keep break point in the Master's ISR 2. Note down the R14 Register 3. Search for the R14 register address in the Map file. Here, the address ...

Texas Instruments (TI) Logic support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search logic IC content or ask ...

I have made a custom PCB using MSP430-FR6047 to measure flow. I wanted to know if it was possible to initialise flow parameters (Parameters under configuration tab in USS Design center) directly ...

Refer to bsl_software_invoke_app_demo_uart_LP_MSPM0G3507_nortos_ticlang, we want to duplicate the same method to enter BSL mode by invokeBSLAsm() on G3107. But MCU ...

My project using TDA4 VM + SDK 9.1 + EMMC boot. Emmc device type is MTFC32GASAQHD-AAT. EMMC boot is normal without special operations.But emmc boot gets stuck when I do the following operation，These ...

I read that the packet sniffer 2 software contains the firmware that enables CC13xx launchpads to be used as capture device. Source: https://dev.ti.com/tirex/explore ...

I have a problem with two different GANG's: old with version 1,04 and new with version 1,05. With GANG's I want to download code to FR6897 microcontroller through JTAG interface. Old GANG downloads ...

Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask ...

I have a pretty large multi-core program for the TMS320C6678L which I want to run on several cores. Because the program is so large I must load it on the DDR3 ram. I split up the program using the ...